This is the way
This is the way
Gotten even easier after X became a registered trademark. Now the only choice we have left is i. Or ii if you need more variables
OK, I may be wrong on this one, and I may have my inbox murdered for this, but I am on the fence here. No, not because I feel the trans woman has any advantages over the other women, but in a sport like fishing, or even esports, there are women’s leagues because the men dominate the current participation rosters, have better sponsors and training and equipment and therefore make it exclusionary to women. Having a women’s league promotes being more inclusive in the sport and creating a level (not fair, level) playing field for those who would typically not get the opportunity to compete.
I know this is further complicated by the fact that trans people are even more marginalized than women, and should therefore have more encouragement to participate in these competitions.
My view is that I would let the trans woman participate, I just also get the fact that some people may have reasonable feelings relating to why they feel this kind of thing does a disservice to them. But then there are other people who are just discriminatory assholes. I get that too.
So what you’re saying is that he wasn’t the good guy with a gun?
If you have a Dremel, grind a slot into it and unscrew it.
If it has a hard backing, you can place a flat head screwdriver on it, give it a few taps, apply loads of pressure and turn it out.
If none of these are possible, a drop of CA adhesive on the screwdriver head, push it against the screw, make sure there is no excess leakage, then use a quick set spray. Once the screw has been turned out, use acetone to remove the glue.
If all of this fails, you gotta drill it. A hand crank drill, and a left handed bit. People seldom have these, so I assume this is your last resort.
Final bit of advice, hit the screw head a couple of times before you try any of these as it loosens the screw a tad. Also, sharpen an old screwdriver tip to just the width and thickness of what is left of the screw head slots. You should be able to find one that is already this size in those screwdriver tip sets
Good luck.